Mon–Fri 09:00–17:00

East Sussex · Surrey · Kent

Gas Safe Registered

Yellow gas main laid in an open trench with barrier tape across a grass verge

Commercial Gas Pipework Testing and Purging

Commercial and industrial gas pipework installed, fabricated, commissioned and decommissioned across East Sussex, Surrey and Kent, with tightness testing, strength testing and purging to 16 bar.

Gas pipework

Tested, purged, proved

Commercial gas pipework is the part of a building that has to be right before anything else can run, and the part that carries the consequences if it is not. Volume, pressure, the route the pipe takes and the way it is proved on completion are all governed, and the work has to be carried out by someone holding the competency for the size of installation in front of them.

Read moreRead less

That competency is TPCP1: tightness testing, strength testing and purging on installation pipework exceeding 1m³ in volume and at pressures up to 16 bar. It is an advanced commercial and industrial gas qualification, and it is the reason we can take on pipework that a domestic registration does not cover.

We install, fabricate, commission and decommission, so a job does not get handed between trades halfway through. The pipework is fabricated to suit the route rather than forced along it, proved before it is charged, and documented on handover.

Copper gas riser and interlock wiring passing through a suspended ceiling
What is included8
  • Commercial and industrial gas pipework installation
  • On site fabrication to suit the route
  • Tightness testing and strength testing
  • Direct and indirect purging, to 16 bar
  • Commissioning and handover documentation
  • Decommissioning and safe removal
  • Pipework alterations and extensions
  • Meter and plant connections

How we work

First call to handover

  1. 01

    Consultation

    We visit the building, survey what is there and scope the work with you.

  2. 02

    Estimate

    A costed proposal written against your budget and your programme.

  3. 03

    Installation

    Installed to specification by our own engineers, tested and handed over.

Recent work in the South East

Gas pipework projects

Yellow gas meter, regulator and valve set in an external brick housing during an annual tightness test
Annual tightness test, industrial site
Orange gas supply pipework to a spray booth with butterfly valve, governor and test point connected for tightness testing
New spray booth gas supply under test
Actuated gas valve and interlock control panel wired into the fire alarm above commercial boiler plant
Gas interlock tied into the fire alarm
Bank of red gas meters and new supply pipework on a brick wall in the meter room of a block of flats
Replacement gas supplies, block of flats
Yellow gas supply pipe in a deep excavation running alongside a brick building
Below ground gas run beside the building
Yellow gas riser with an isolation valve emerging from an excavation beside a flint wall
Excavation and entry at the building

Our services

What else we do

Accredited and registered

Gas Safe Register
CHAS accredited contractor
PQS Pre-Qualification-Scheme, SSIP registered, health and safety approved

PQS certificate NP350717169, valid to 11 July 2027. View the certificate Verify on the SSIP portal

Get in touch

Tell us what you need

And ask about our installation, maintenance and repair services.